Tools Required: Screwdriver, pliers/cutters

Installation:

Locate access to the third brake light wires. The easiest access to them is from where you change the existing bulb or LED bar.

Place a “Quick Connect” connector over the positive (+) side wire going to the third brake light and insert the Red wire. Using the pliers, squeeze the metal splice to secure the wires and then snap the cover closed.

1.        Place a “Quick Connect” connector over the same positive (+) side wire going to the third brake light, but between where you attached and the Red wire and light

2.        Insert the Blue wire and squeeze and snap as before

3.        Place a “Quick Connect” connector over the negative (-) side wire (any chassis ground) and insert the black wire. Squeeze and snap as before.

4.        Cut the positive (+) side wire between where you attached the Red and Blue wires from the SBL unit.

5.        Fit the Safer Brake Light inside somewhere away from areas of high temperature,

moisture, and water leakage.

Note: The wiring in most vehicles vary because of the age of the vehicle. Please ensure the “Quick Connect” has cut through the wire insulation and has good connection.

For auto safety accessories, lighting and other laws vary from state to state. We make no representation or warranty to the legality of its products for street use on any vehicle or in any location.